VERY IMPORTANT SAFETY INFO!Adjust the tether cord that connects to the pin quick release clamp on the bottom of the board so that you can reach it while strapped into the boots. Make sure it has enough slack to allow you to lean forward...

DO NOT over tighten screws. Only hose and U pipe clamp screws need to be very tight. Make sure to re-torque each clamp before first use. Do it every time before you go out on the water for the day! Protect your clamps and bolts with...

Do this each time before flying.Re-torque all clamps before use. Make sure all screws in clamps are very tight. Torque to 18 NM. Inspect the U pipe for any damage. Make sure all quick connect fittings are in proper position placement. ...

To make sure that your Wataboard lasts you many years please follow recommended maintenance:Inspect ball bearings inside each nozzle and swivel every 20 hours of use. If you hear any cracking or crunching sound there is probably dirt...

You can use any wakeboard style bindings with a 6 inch (153mm) mounting bolt spacing. Open toe boots with Velcro instead of laces are highly recommended. We also recommend using properly sized bindings that fit you correctly.Make sure to use...

Your venturi + steering nozzle that came off your jet ski should be attached to the Quick Disconnect Steering plate with four (4) bolts that came with your order. After assembling your assembly should look something like the pictures below.

You will need to remove the stock venturi/nozzle and turning mechanism from your jetski. After that you will be able to mount the jet pump adapter plate to the back of your jet ski with the included bolts.SeaDoo: If you have a Sea-Doo with a...

Insert one ends of the hose with the Wataboard logo over the swivel hose barb and secure with clamps size 110-120. Make sure that each clamp fits into the groove of the hose barb. Easiest way to line up the hose with the grooves is to use...

Step 1. Assemble one end of the 13 foot booster hose to the U pipe with two (2) 120-130 steel clamps. Step 2. Connect or closely align the U pipe to the back of the jet ski and stretch out the booster hose towards the front of the jet ski. Make...

Age and Weight 1. Persons MUST be 18 years of age or older to use the Wataboard. 2. No Operator can weigh over 375 lbs.Equipment Required (Operators must wear this equipment at all times while using the Wataboard) 1. Coast Guard approved...